Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2020 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control Module Diagnosis >> DTC B163E-00: Rain Sensor Module LIN Fault >> Wiring Inspection >> LIN Communication Circuit Inspection >> Check Open And Short-To-Ground

Check Open And Short-To-Ground

  1. IG key "OFF".
  2. Disconnect IBU*_BCM connector, WMM* connector and "WIPER MOTOR" connector.
  3. Measure the resistance between "LIN" terminal of IBU*_BCM harness connector and "LIN" terminal of RSM* harness connector.

    Specification  : Below approx. 1Ω

  4. Measure the resistance between "LIN" terminal of RSM* harness connector and chassis ground.

    Specification  : Infinity (∞)

  5. Is the measured resistance within specification?

    YES 

    • Go to next procedure.

    NO 

    • Check open/poor connection between "LIN" terminal of IBU*_BCM and "LIN" terminal of RSM* harness connector.
    • Check short between "LIN" terminal of RSM* harness connector and chassis ground.

      → Repair or replace as necessary, go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About Mike's Workshop Manuals