Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2019 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 198 (Body Control Module Diagnosis) >> DTC B163E-00: Rain Sensor Module LIN Fault >> Verification of Repair >> Verification of Vehicle Repair

Verification of Vehicle Repair

WARNING: This page is about a different car, the 2017 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect GDS and select "Diagnostic Trouble Codes (DTC)"  mode.
  2. Erase the DTCs and Operate the vehicle within DTC Enable conditions in General Information.
  3. Is any DTC output again?

    YES 

    • Go to the applicable troubleshooting in this procedure.

    NO 

    • System performing to specification at this time.
scientia non olet · About Mike's Workshop Manuals