Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2019 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Multi-View Camera System) >> Repair Procedures >> Inspection >> Diagnosis

Repair Procedures: Inspection: Diagnosis

WARNING: This page is about a different car, the 2017 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check Output Video on the Multi-view Camera Head Unit Screen

    If the video is not displayed normally in the Multi-view Camera Video Check Phase, then perform below check list and check the video again.

    1. Are the connector for each camera properly connected?
    2. Is there any obstacles in the camera's view angle?
    3. Is the Multi-view Camera ECM operating properly?
  2. In case Tolerance Compensation Mode cannot be entered
    1. Is the shift lever position at 'N' range?
    2. Is the vehicle parked?
    3. Is the GDS in Tolerance Compensation Mode?
  3. In case Compensation Point is not recognized

    If the compensation point is incorrectly recognized or not recognized at all at the Compensation Point Recognition Phase, then perform below check list and re-input the compensation point.

    1. Check that work area is not exposed to the sun light.
    2. Check that the work area is not exposed to other vehicle's head lamp or other source of light.
    3. Check if there is reflection of light on the compensation board and the AVN cannot recognize the Compensation Board Indication.
    4. Check that there is no other object on the Compensation Board.
    5. Check that there is no debris on the camera lens, or that the Compensation Board indication is difficult to recognize due to lens protection film.
    6. Check that there is no other object adjacent to the Compensation Board Indication, which may also create a shadow on the Compensation Board Indication.
    7. Check that there is no obstacle blocking the camera view while performing compensation task.
    CAUTION:
    • The recognition procedure for the Multi-view Camera compensation point is sensitive to light reflected off the floor.
    • The task is sensitive to the impact of external light sources (sunshine and reflected light from the floor) and it is recommended that a screen should be placed around the work place (8.5 x 5.2 m).
    • Carry out compensation in the work place where the floor surface is painted green and there is no glare.
scientia non olet · About Mike's Workshop Manuals