Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2019 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Steering Column Module Diagnosis) >> DTC B1602-00: CAN Line Error >> Verification of Repair >> Verification of Vehicle Repair

Verification of Vehicle Repair

WARNING: This page is about a different car, the 2017 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect scan tool and select "Diagnostic Trouble Codes (DTC)"  mode
  2. Using a scan tool, clear the DTC.
  3. Operate the vehicle within DTC Enable conditions in General Information.
  4. Are any DTC present?

    Yes 

    • Go to the applicable troubleshooting in this procedure.

    No 

    • System is performing to specification at this time.
scientia non olet · About Mike's Workshop Manuals