Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Genesis G90. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative (-) battery terminal.
Remove the rear bumper.
(Refer to Body - "REAR BUMPER ")
Remove the BSD unit (A) after loosening the mounting nuts.
[LH]

Fig 1: Locating BSD Unit And Mounting Nuts (LH)
Courtesy of HYUNDAI MOTOR AMERICA

[RH]

Fig 2: Locating BSD Unit And Mounting Nuts (RH)
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Take care not to separate the bracket from rear bumper when removing the BSD sensor.