Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2019 >> G80 3.8, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 3.8L >> Knock Sensor (KS) >> Repair Procedures >> Removal >> [Knock Sensor #2 (Bank 2)]

[Knock Sensor #2 (Bank 2)]

  1. Turn the Ignition Switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the Knock Sensor Connector (A).
    G12657632Courtesy of HYUNDAI MOTOR AMERICA
  3. Drain the Engine Coolant.

    (Refer to Engine Mechanical System - "COOLING SYSTEM ")

  4. Remove the Radiator Upper Hose.

    (Refer to Engine Mechanical System - "COOLING SYSTEM ")

  5. Remove the Coolant Pipe [Bank 2].

    (Refer to Engine Mechanical System - "COOLING SYSTEM ")

  6. Remove the Oil Level Gauge.

    (Refer to Engine Mechanical System - "COOLING SYSTEM ")

  7. Remove the Installation Bolt (A), and then remove the sensor from the Cylinder Block.
    G12657633Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals