Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2019 >> G80 3.8, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 3.8L >> Knock Sensor (KS) >> Repair Procedures >> Removal >> [Knock Sensor #1 (Bank 1)]

[Knock Sensor #1 (Bank 1)]

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the Knock Sensor connector (A).
    G12657630Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the installation bolt (A), and then remove the Sensor from the Cylinder Block.
    G12657631Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals