Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2019 >> G70 3.3T Design, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 2.0L) >> ETC (Electronic Throttle Control) System >> Repair Procedures >> Adjustment >> ETC module learning procedure

ETC module learning procedure

WARNING: This page is about a different variant/trim than selected.

Be sure to perform the ETC module learning procedure when replacing or reinstalling the ETC module.

  1. Wait for 1 minute with the ignition switch ON.
  2. Start the engine and hold the idle status for 15 minutes.
  3. Wait for 1 minute with the ignition switch OFF.
  4. Restart the engine, and check that the idle speed is stable.
    NOTE:
    • If the ETC module learning procedure is not performed after replacing or reinstalling it, MIL illumination with DTCs may occur.
scientia non olet · About Mike's Workshop Manuals