Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2019 >> G70 3.3T Design, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control Module Diagnosis >> DTC B1602-00: CAN Error >> DTC Information And Inspection >> Monitor DTC Status

Monitor DTC Status

  1. Connect the GDS and select "System". → "BCM". → "Diagnostic Trouble Codes (DTC)".
  2. Click the "DTC Status" to check the DTC information.
  3. Read the "DTC Status" parameter, and Record all DTCs, DTC state and freeze frame data.
  4. Is the same DTC set again?

    YES 

    NO 

    • This can be BCM* memory was not cleared after repair.

      → Erase the DTCs, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    • This can be an intermittent fault caused by Poor Contact in BCM*'s and/or B-CAN communication unit/module's connector.

      → Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

      → Repair or replace the harness/connector as necessary, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

NOTE: BCM*: "IBU".
scientia non olet · About Mike's Workshop Manuals