Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2019 >> G70 2.0T Advanced, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis - 2.0L (2 Of 4) >> DTC P0564-00: Cruise Control Multi-Function Input A Circuit >> Wiring Inspection >> Signal Circuit Inspection >> Check Open In Signal Circuit

Check Open In Signal Circuit

  1. Turn "OFF" the ignition switch. Disconnect 'CRUISE REMOCON SWITCH' connector and ECM connector.
  2. Measure resistance between 'Signal (Cruise SW)' terminal of 'CRUISE REMOCON SWITCH' harness connector and 'Signal (Cruise SW)' terminal of ECM connector.

    Specification  : Below 1.0Ω

  3. Is the measured value within specification?

    YES 

    NO 

    • Repair open between 'Signal (Cruise SW)' terminal of 'CRUISE REMOCON SWITCH' harness connector and 'Signal (Cruise SW)' terminal of ECM connector, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals