Component Inspection

Disassemble Fuel Level Sender with ignition switch turned "OFF".

Measure resistance between signal terminal and ground terminal of Fuel Level Sensor with moving the float. (Component side)

Specification

(Analog Gauge)

Float Position	S/F	8/8	7/8	6/8	5/8	4/8	3/8
Sender Resistance (Ω)	15±1	20±1.5	32±1	45±1	62±1	82±1	108±2
Fuel remaining (L)	68.6	65.1	57.8	50.4	43.1	35.7	28.4

Float Position	2/8	1/8	Warning	G/E	S/E
Sender Resistance (Ω)	142±2	188±3	233±3	255±3	300±3
Fuel remaining (L)	21	13.7	8.5	6.3	3

(Dial Gauge)

Float Position	S/F	16/16	15/16	14/16	13/16	12/16	11/16
Sender Resistance (Ω)	15±1	20±1.5	26±1	32±1.5	38±1	45±1	53±1
Fuel remaining (L)	68.6	65.1	61.4	57.8	54.1	50.4	46.7

Float Position	10/16	9/16	8/16	7/16	6/16	5/16	4/16
Sender Resistance (Ω)	62±1	72±2	82±2	95±2	108±2	124±2	142±2
Fuel remaining (L)	43.1	39.4	35.7	32	28.4	24.7	21

Float Position	3/16	2/16	1/16	Warning	G/E	S/E
Sender Resistance (Ω)	163±2	188±3	218	233±2	255±2	300±3
Fuel remaining (L)	17.3	13.7	10	8.5	6.3	3

Is resistance within the specification?
YES
- Thoroughly check that any foreign material interrupts float moment. Erase DTC and drive the vehicle to satisfy the enable condition then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known-good Fuel Sender and check for proper operation. If the problem is corrected, replace Fuel Sender and go to "VERIFICATION OF VEHICLE REPAIR " procedure.