Oil Temperature Sensor Inspection

Measure the resistance between signal terminal and ground terminal of OTS connector. (Component side)

Specification: Approx. 5V

Temp. (°C)	Temp. (°F)	Resistance (kΩ)	Temp. (°C)	Temp. (°F)	Resistance (kΩ)
-20	-4	16.52	40	104	1.11
0	32	6	60	140	0.54
20	68	2.45	80	176	0.29

Is the measured resistance within specification?
YES
- Clear DTC and Test-drive under the enable conditions. After the road test, if this DTC is set, recheck resistance. If not, it is intermittent fault. Go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Check OTS for contamination, deterioration, or damage. Substitute with a known-good OTS and check for proper operation. If the problem is corrected, replace OTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.