Monitor GDS Data
- Connect GDS to Data Link Connector (DLC).
- Turn the ignition ON and start the engine.
- Select "Diagnostic Trouble Codes (DTC)," and click "DTC Status" to check DTC information.
- Read the "DTC State" parameter.
- Is the DTC state "Present?".
YES
- Replace the LDWS/LKAS with usable ones and check for proper operation. Go to "VERIFICATION OF VEHICLE REPAIR ".
*If the LDWS/LKAS is replaced, calibrate the camera.
NO
- This can be an intermittent fault caused as the LDWS/LKAS' memory was not cleared after repair. Go to "VERIFICATION OF VEHICLE REPAIR ".
- Replace the LDWS/LKAS with usable ones and check for proper operation. Go to "VERIFICATION OF VEHICLE REPAIR ".