Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2018 >> G80 3.3T Sport, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 3.3L >> Camshaft Position Sensor (CMPS) >> Repair Procedures >> Removal >> [Bank 2]

[Bank 2]

WARNING:
  • DON'T remove the Camshaft Position Sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
  1. Turn the Ignition Switch OFF and disconnect the battery negative (-) cable.
  2. Remove the Surge Tank.

    (Refer to Engine Mechanical System - "SURGE TANK ")

  3. Disconnect the Camshaft Position Sensor Connector (A).
  4. Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.

    [Bank 2/Intake] 

    G12663670Courtesy of HYUNDAI MOTOR AMERICA

    [Bank 2/Exhaust] 

    G12663671Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals