Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 3.3L) >> Rail Pressure Sensor (RPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE " in this procedure).
    CAUTION:
    • When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.
  3. Remove the intake manifold (Refer to "INTAKE & EXHAUST SYSTEM - 3.3L " in EM procedure).
  4. Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
Fig 1: Rail Pressure Sensor And Connector
G11412181Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals