Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 3.3L) >> ETC (Electronic Throttle Control) System >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.

    (Refer to Engine Mechanical System - "INTAKE & EXHAUST SYSTEM - 3.3L ")

  2. Disconnect the ETC module connector (A).
  3. Disconnect the coolant hose (B).
  4. Remove the ETC module from the engine after loosening the installation bolt (C).
Fig 1: ETC Module And Installation Bolts
G11412133Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About Mike's Workshop Manuals