Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (I-Box Module Diagnosis) >> DTC B1602-00: CAN Line Error >> DTC Inspection >> Monitor GDS Data

Monitor GDS Data

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Vehicle Parked & Ignition ON.
  2. Connect GDS and select "DTC Analysis" mode.
  3. Click "DTC Status" on the "Diagnostic Trouble Codes (DTC)"  menu bar to see DTC's information.
  4. Confirm that "DTC Readiness Flag" indicates "COMPLETED". If not, drive the vehicle within conditions noted in the freeze frame data or enable conditions.
  5. Read "DTC Status" parameter.
    G11353894Courtesy of
  6. Is parameter displayed "Present fault"?

    YES 

    • Go to Next procedure.

    NO 

    • Fault is intermittent caused by poor contact in the sensor's and/or Control module's connector or was repaired and Control module's memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About Mike's Workshop Manuals