Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Supplemental Restraint System Control Module & Sensors) >> Occupant Classification System (OCS) >> Repair Procedures >> Installation >> OCS Ecu

OCS Ecu

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the OCS ECU on the Front seat track assembly.
  2. Connect the OCS ECU connector.
  3. Install the front passenger seat assembly.

    (Refer to Body - "FRONT SEAT ")

  4. Reconnect the battery negative cable.
  5. After installing the OCS, confirm proper system operation:
    • Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
    • Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the OCS does not require suppression and the passenger airbag is enabled.
    NOTE: Be sure to perform OCS reset with GDS after replacing OCS equipped seat cushion.
scientia non olet · About Mike's Workshop Manuals