Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transmission Control System) >> Inhibitor Switch >> Repair Procedures >> Inspection >> Signal Circuit Inspection

Signal Circuit Inspection

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the Inhibitor switch connector.
  2. Turn the ignition key ON and the engine OFF.
  3. Measure voltages between each terminal and chassis ground while the shift lever changes from P to R, N and D.

    Specification:  See below "SIGNAL CODE TABLE "

scientia non olet · About Mike's Workshop Manuals