Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 315 (Automatic Transaxle Control System) >> Inhibitor Switch >> Repair Procedures >> Inspection >> Signal Circuit Inspection

Signal Circuit Inspection

WARNING: This page is about a different car, the 2016 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the Inhibitor switch connector.
  2. Ignition KEY "ON" & Engine "OFF".
  3. Measure the voltages between each terminal and chassis ground in each range (P, R, N, D).
    SIGNAL CODE DESCRIPTION

      P P-R R R-N N N-D D
    Signal "1" 12V 12V 0 0 0 0 0
    Signal "2" 0 12V 12V 12V 0 0 0
    Signal "3" 0 0 0 12V 1 V 12V 0
    Signal "4" 0 0 0 0 0 12V 12V
scientia non olet · About Mike's Workshop Manuals