Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 5.0 Ultimate, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Blind Spot Detection System >> Blind spot Detection Unit >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the rear bumper.

    (Refer to Body - "REAR BUMPER ")

  3. Remove the BSD unit (A) after loosening the mounting nuts.

    [LH] 

    Fig 1: Locating BSD Unit And Mounting Nuts (LH)
    G11419885Courtesy of HYUNDAI MOTOR AMERICA

    [RH] 

    Fig 2: Locating BSD Unit And Mounting Nuts (RH)
    G11419886Courtesy of HYUNDAI MOTOR AMERICA
    NOTE: Take care not to separate the bracket from rear bumper when removing the BSD sensor.
scientia non olet · About Mike's Workshop Manuals