Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 3.3T Premium, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Airbag Modules And Clock Spring) >> Knee Airbag (KAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative cable and wait for at least three minutes.
  2. install the Knee airbag.

    Tightening torque: 

    7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

  3. Install the crash pad lower panel.

    (Refer to Body - "CRASH PAD LOWER PANEL ")

  4. Reconnect the battery negative cable.
  5. After installing the knee airbag, confirm proper system operation.

    Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

scientia non olet · About Mike's Workshop Manuals