Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 3.3T Premium, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Airbag Modules And Clock Spring) >> Curtain Airbag (CAB) Module >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF.
  2. Disconnect the battery negative cable and wait for at least three minutes.
  3. Tighten the curtain airbag mounting bolts.

    Tightening torque: 

    11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.9 lb-ft)

    CAUTION: Never twist the airbag module when installing it. If the module is twisted, the airbag module may operate abnormally.
  4. Connect the curtain airbag connector.
  5. Install the roof trim assembly.

    (Refer to Body - "ROOF TRIM ASSEMBLY ")

  6. Reconnect the battery negative cable.
  7. After installing the curtain airbag (CAB), confirm proper system operation:

    Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

scientia non olet · About Mike's Workshop Manuals