Repair Procedures: Inspection
WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Measure the output voltage between the terminal of the wheel speed sensor and the body ground.NOTE: To protect the wheel speed sensor when measuring the output voltage, a 100 Ω resister must be used as shown in illustration below.
- Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown in illustration below.
V_low: 0.59V ~ 0.84V
V_high: 1.18V ~ 1.68V
Frequency range: 1 ~ 2, 000Hz