Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 3.3T Premium, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Engine Control System - 5.0L) >> Rail Pressure Sensor >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE " in this group).
    CAUTION: When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS Repair Procedures after completion of "Release Residual Pressure in Fuel Line" work.
  3. Remove the intake manifold.

    (Refer to INTAKE & EXHAUST SYSTEM - 5.0L Engine Mechanical System )

  4. Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
G11336689
scientia non olet · About Mike's Workshop Manuals