Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G90 3.3T Premium, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Windshield Wiper/Washer System) >> Front Washer Motor >> Repair Procedures >> Inspection >> Washer Fluid Level Sensor Switch

Washer Fluid Level Sensor Switch

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative (-) battery terminal.
  2. Drain the washer tank until the washer fluid is less than 650 cc.
  3. Check for continuity between the No. 1 and No. 2 terminal in each float position.

    There should be continuity when the float is down.

    There should be no continuity when the float is up.

  4. If the continuity is not as specified, replace the washer fluid level switch
G11342531Courtesy of
G11342532Courtesy of
G11342533Courtesy of
scientia non olet · About Mike's Workshop Manuals