Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G80 5.0 Ultimate >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System - 3.8L) >> Manifold Absolute Pressure Sensor (MAPS) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Install the component with the specified torques.
  • Note that internal damage may occur if the component drops. If the component drops, inspect it before installation.
CAUTION:
  • Insert the sensor in the installation hole and be careful not to damage during installation.
  1. To install, reverse the removal procedure.

    Manifold absolute pressure sensor Installation bolt: 

    7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

scientia non olet · About Mike's Workshop Manuals