Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Genesis >> 2017 >> G80 5.0 Ultimate >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Control Diagnosis >> DTC C1513: Brake Switch Circuit Error >> DTC Information >> DTC Detecting Condition

DTC Information: DTC Detecting Condition

Item Detecting Condition Possible cause
DTC Strategy
  • Circuit monitoring
  1. Open or short circuit in brake switch line
  2. Faulty brake light switch
  3. Faulty Stop Signal Electronic Module
Enable Conditions
  • Outside an ABS/ESP (ESC) control, If the pressure sensor signal is higher than 15bar and BLS is OFF for 1sec, The failure is detected when the case occurs 3 times in same ignition cycle
  • While reference vehicle speed > 20 km/h (12 mph), master cylinder pressure <; 7bar, if brake light switch is ON longer than 2min. The failure is detected when the case occurs 3times in same ignition cycle
Fail-Safe
  • Inhibit the ESP (ESC)/DBC/AVH control and allow the ABS/EBD control
  • The ESP (ESC)/DBC/AVH warning lamp is activated
scientia non olet · About Mike's Workshop Manuals