Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

Intake Air Pressure and Temperature Sensor (2) - Install

CAUTION:

Intake Air Pressure and Temperature Sensor Bolt (1) - Install and tighten 5 N.m (44 lb in)
Connect the intake air pressure and temperature sensor electrical connector.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Fuel Feed Hose Clip Bracket (2) - Install
Fuel Feed Hose Protector Bolt (1) - Install and tighten 9 N.m (80 lb in)
Perform the intake system learned values reset. Intake System Learned Values Reset