Installation Procedure
Active Safety Control Module Bracket (3) - Install
- Wiring Harness Retainer (2) - Install
- Active Safety Control Module Bracket Nut (1) - Install and tighten [3x] - Fastener Specifications
Image Processing Module (3) - Install
- Active Safety Control Module Nut (2) - Install and tighten [3x] - Fastener Specifications
- Connect the electrical connectors (1).
Connect the electrical connector.
- Quarter Lower Rear Trim Panel- Left Side (1) - Install
Rear End Trim Finish Panel (1) - Install
Liftgate Lock Striker Cover (1) - Install
Rear Compartment Floor Stowage Compartment Divider (1) - Install
Rear Compartment Floor Stowage Compartment Divider Retainer (1) - Install and tighten [4x] - Fastener Specifications
Adjust the springs (2) to make rear compartment floor panel front trim (1) engage the rear compartment floor stowage compartment divider.
- Rear Compartment Floor Panel Front Trim (1) - Install
Load Floor Trim Panel (1) - Install
Cargo Tie Down Loop (3) - Install [2x]
- Cargo Tie Down Loop Bolt (2) - Install and tighten [2x] - Fastener Specifications
- Cargo Tie Down Loop Trim Cover (1) - Install [2x]
{ If equipped } Rear Wheelhouse Trim Finish Panel Stowage Box (1) - Install
Connect the electrical connector.
- Body Rear Corner Upper Garnish Molding (1) - Install
Body Rear Corner Upper Garnish Molding Bolt (2) - Install and tighten - Fastener Specifications
- Quarter Window Trim Finish Panel Bolt Cap (1) - Install
Quarter Upper Trim Panel (3) - Install
- Quarter Window Trim Finish Panel Bolt (2) - Install and tighten - Fastener Specifications
- Body Lock Pillar Upper Trim Panel Bolt Hole Plug (1) - Install
Rear Side Door Sill Garnish Molding (1) - Install
- Enable the SIR System. SIR Disabling and Enabling
- Perform the necessary programming and setup procedure:Control Module References
Refer to Fastener Caution .