Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2019 >> Terrain SL >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Lighting System - Repair Instructions) >> Repair Instructions >> Brake Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2018 GMC Terrain and 2018 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Brake Pedal Position Sensor
    GM4597389Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Position the fork of the brake pedal position sensor over the post on the brake pedal.

  1. Install Brake Pedal Position Sensor (1).
    2. Fig 2: Brake Pedal Position Sensor Bolt
    GM4597388Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install Brake Pedal Position Sensor Bolt (1) and tighten 3 N.m (27 lb in)
    3. Fig 3: Electrical Connector
    GM4597386Courtesy of GENERAL MOTORS COMPANY
  3. Connect Electrical Connector (1).
  4. Install Floor Front Air Outlet Duct - Left Side -Floor Front Air Outlet Duct Replacement - Left Side
  5. Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration 
scientia non olet · About Mike's Workshop Manuals