Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2019 >> Sierra 2500 HD Base, 2D Pickup, Gas >> Repair and Diagnosis >> External Pages >> Different car >> Section 3125 (Remote Functions System) >> Diagnostic Information And Procedures >> Keyless Entry System Malfunction >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Sierra 3500 HD, 2018 GMC Sierra 2500 HD, 2018 GMC Sierra 1500, 2018 Chevrolet Silverado 3500 HD, and 2018 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Operate the transmitter while observing the scan tool Key Fob Function parameter for the appropriate transmitter.
  2. Verify the scan tool Key Fob Function parameter corresponds with the function selected on the transmitter.
    • If the Key Fob Function parameter does not correspond with the transmitter selection 
      NOTE:

      Before replacing the transmitter, inspect the transmitter battery contacts for any corrosion or damage. If no corrosion or damage is found, replace the transmitter battery and retest before replacing the transmitter.

    1. Replace the transmitter.
    2. Operate the new transmitter while observing the scan tool Key Fob Function parameter for the transmitter.
    3. Verify the scan tool Key Fob Function parameter correspond with the function selected on the transmitter.
      • If the Key Fob Function parameter does not correspond with the transmitter selection 

        Perform Circuit/System Testing.

    • Go to next step: If the Key Fob Function parameter corresponds with the transmitter selection 
  3. All OK.
scientia non olet · About Mike's Workshop Manuals