Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2016 >> Canyon SL >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.5L (LCV) - DTC P0010 To DTC P0420 >> Diagnostic Information and Procedures >> DTC P00F4-P00F6: Intake Air Humidity Sensor >> Circuit/System Verification

Circuit/System Verification

NOTE:

To minimize the effects of residual engine heat and sensor internal heating elements, perform Steps 1 and 2 of this verification procedure only if the ignition has been OFF for 8 hours or more.

  1. Ignition ON.
  2. Verify the following scan tool parameters are within 30°C (54°F) of each other.
    • Start-Up IAT Sensor 1
    • IAT Sensor 2
    • Start-Up ECT Sensor
    • If not within 30°C (54°F) 

      Refer to Circuit/System Testing.

    • If within 30°C (54°F) 
  3. Engine idling, verify the scan tool Intake Air Humidity parameter is between 5 and 90 %.
    • If not between 5 and 90 % 

      Refer to Circuit/System Testing.

    • If between 5 and 90 % 
  4. Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
  5. Verify the DTCs do not set.
    • If any of the DTCs set 

      Refer to Circuit/System Testing.

    • If none of the DTCs set 
  6. All OK
scientia non olet · About Mike's Workshop Manuals