Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2014 >> Terrain SLT, 4D Utility >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Front Suspension System) >> Repair Instructions >> Strut Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Terrain and 2010 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Strut Mount Bolts
    GM1467198Courtesy of GENERAL MOTORS CORP.
  1. Position the strut assembly to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the 3 upper strut mount bolts and tighten to 25 N.m (18 lb ft).
    3. Fig 2: Identifying Steering Knuckle To Strut Bolts & Nuts
    GM1826249Courtesy of GENERAL MOTORS CORP.
  3. Install the lower strut bolts and nuts and tighten to 200 N.m (148 lb ft).
    4. NOTE: Inspect the stabilizer link seals for damage prior to installation. Replace as required.
    NOTE: Do not allow the stabilizer link ball stud to rotate while installing the link nut.
  4. Install the stabilizer link to the front strut. Refer to Stabilizer Shaft Link Replacement .
  5. Install the brake hose bracket to the front strut. Refer to Front Brake Hose Replacement .
  6. Install the wheel and tire. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
  8. Install the air inlet screen. Refer to Air Inlet Screen Replacement (Equinox) or Air Inlet Screen Replacement (Terrain)
  9. Perform a wheel alignment. Refer to Wheel Alignment Measurement .
scientia non olet · About Mike's Workshop Manuals