Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2011 >> Yukon Hybrid, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - Hybrid (LZ1) - Repair Instructions >> Repair Instructions >> Fuel Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Chassis Wiring Harness Electrical Connector, Fuel Pressure Sensor And Fuel Pipe Bracket
    GM1964193Courtesy of GENERAL MOTORS CORP.
  1. If equipped with 4 wheel drive (4WD), remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
  2. Disconnect the chassis wiring harness electrical connector (1) from the fuel pressure sensor (2).
    3. Fig 2: Fuel Pressure Sensor And O-ring Seal
    GM1964194Courtesy of GENERAL MOTORS CORP.
  3. Wrap a shop towel around the fuel pressure sensor fitting in order to absorb any fuel that may leak out.
  4. Remove the fuel pressure sensor (1) from the fuel line.
  5. Remove and discard the fuel pressure sensor O-ring seal (2).
scientia non olet · About Mike's Workshop Manuals