Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2011 >> Yukon Hybrid, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - Hybrid (LZ1) - Repair Instructions >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

CAUTION:

Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

    Fig 1: Engine Wiring Harness Electrical Connector, Clip, Bolt And ECT Sensor
    GM1960215Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system to a level below the engine cooling temperature (ECT) sensor. Refer to Cooling System Draining and Filling (Static Fill) .
  2. Disconnect the engine wiring harness electrical connector (2) from the ECT sensor (1).
    3. Fig 2: Engine Coolant (ECT) Sensor
    GM855737Courtesy of GENERAL MOTORS CORP.
  3. Remove the ECT sensor.
scientia non olet · About Mike's Workshop Manuals