Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2011 >> Terrain SLT, 2.4 C, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.4L - DTC P0010 Through P025A >> DTC P0107 or P0108 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF for 90 s, disconnect the harness connector at the B74 MAP sensor.
  2. Test for less than 5 Ω between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  3. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal 1 and ground.
    • If less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 ECM.
    • If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K20 ECM.
  4. Verify the scan tool MAP Sensor parameter is less than 1 kPa.
    • If greater than the specified range, test the signal circuit terminal 3 for a short to voltage. If the circuit tests normal, replace the K20 ECM.
  5. Install a 3 A fused jumper wire between the signal circuit terminal 3 and the 5 V reference circuit terminal 1. Verify the scan tool MAP Sensor parameter is greater than 127 kPa.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  6. If the circuits test normal, test or replace the B74 MAP sensor.
scientia non olet · About Mike's Workshop Manuals