Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2008 >> Yukon Base, 4.8 C >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Hybrid Engine Control System) >> Diagnostic Information and Procedures >> DTC P0C2F >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Diagnose ECM DTCs P0335 and P0336 prior to performing this procedure.
  1. Repair the following conditions if observed:
    • ECM CKP sensor DTCs
      • IMPORTANT: If mechanical binding of the engine is observed, internal transmission damage may have resulted when drive motor 1 attempted to crank the seized engine.
    • Mechanical condition which would cause drive motor 1 to rotate without a corresponding rotation of the engine.
  2. Ignition ON, retest for DTC P02CF.
    • If the DTC resets, test each drive motor generator position sensor for proper operation. Refer to DTC P1B03 or P1B04 .
scientia non olet · About Mike's Workshop Manuals