Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2008 >> Acadia SLT, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC B1405 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the battery current sensor.
  2. Ignition OFF, test for less than 1 ohm between the low reference circuit terminal B and ground.
    • If greater than the specified value, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
  3. Ignition ON. Test for 4.8-5.2 volts between the 5-volt reference circuit terminal A and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, then replace the BCM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests normal, then replace the BCM.
  4. Ignition ON, test for 4.8-5.2 volts between the signal circuit terminal C and ground.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the battery current sensor.
scientia non olet · About Mike's Workshop Manuals