Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2007 >> Sierra Classic 1500 HD, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Cellular System, Entertainment System, And Navigation System >> Repair Instructions >> Digital Radio Receiver Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Digital Radio Receiver & Wire Connector
    GM854856Courtesy of GENERAL MOTORS CORP.
  1. Connect the coaxial cable.
  2. Connect the wire connector.
  3. Install the receiver and bracket assembly to the I/P.
    4. NOTE: Refer to Fastener Notice .
  4. Install the 2 retaining screws (1).

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  5. Install the right side junction block to the I/P. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Right Side .
  6. Close the I/P compartment door.
  7. Perform the setup procedure for the digital radio receiver. Refer to Control Module References for programming and setup information.
scientia non olet · About Mike's Workshop Manuals