Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2007 >> Acadia SLT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Wheel Alignment System) >> Repair Instructions >> Rear Toe Adjustment

Rear Toe Adjustment

WARNING: This page is about a different car, the 2005 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Loosening Inner Toe Link Cam Bolt And Nuts
    GM1237901Courtesy of GENERAL MOTORS CORP.
  1. Loosen the inner toe link cam bolt and nuts.
  2. Rotate the cam bolt to the required toe specification settings. Refer to Measuring Wheel Alignment .
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Maintain the toe setting while tightening the cam bolt nut.

    Tighten:  Tighten the rear suspension adjustment link lock nut to 110 N.m (81 lb ft).

  4. Check the toe setting after tightening.
  5. Adjust the toe setting if necessary.
scientia non olet · About Mike's Workshop Manuals