Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2007 >> Acadia SLT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 546 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P0703 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Fix any brake system related DTCs before using this diagnostic.
IMPORTANT: This DTC may be stored as a history DTC without affecting the operation of the ECM. Do not replace the BCM or ECM if this DTC is stored only as a history DTC and is not retrieved as a current DTC.
  1. Ignition ON, perform the brake pedal position (BPP) sensor calibration procedure and verify the BPP is calibrated properly. Refer to Brake Pedal Position Sensor Calibration .
    • If the BPP will not calibrate properly, replace the BPP.
  2. Cycle the ignition, apply and release the brake pedal. Using a scan tool, check for DTC P0703 in the ECM.
    • If DTC P0703 is current in the ECM, replace the ECM.
    • If DTC P0703 is not current in the ECM, the system is OK.
scientia non olet · About Mike's Workshop Manuals