Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2007 >> Acadia SLT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 501 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (LZ9) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Generator Lower Bolt & Stud
    GM1584688Courtesy of GENERAL MOTORS CORP.
  1. Install the generator.
  2. Install the generator lower bolt and stud until snug.
    3. Fig 2: Identifying Generator Upper Bolt
    GM1584686Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the generator upper bolt.

    Tighten:  Tighten the bolts/stud to 50 N.m (37 lb ft).

    4. Fig 3: View Of Generator
    GM1584684Courtesy of GENERAL MOTORS CORP.
  4. Install the engine harness terminal (2).
  5. Install the engine harness terminal nut (1).

    Tighten:  Tighten the nut to 30 N.m (22 lb ft).

  6. Position the generator rubber boot (3).
  7. Connect the engine harness electrical connector.
  8. Install the drive belt. Refer to Drive Belt Replacement (Coupe) or Drive Belt Replacement (Convertible) .
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals