Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2007 >> Acadia SLT, AWD >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

Fig 1: Turning Ignition Lock Cylinder To RUN Position
GM874786Courtesy of GENERAL MOTORS CORP.
IMPORTANT: If you are installing a new lock cylinder, refer to Key and Lock Cylinder Coding .
  1. Position the ignition lock cylinder in the run position and insert it into the lock housing.
  2. Rotate the ignition lock cylinder in the housing. Verify proper rotation.
  3. Install the ignition lock cylinder opening trim cover. Refer to Ignition Lock Cylinder Opening Trim Cover Replacement .
  4. Install the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals