Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2005 >> Jimmy Part Time, Standard >> Repair and Diagnosis >> Body & Frame >> Windows >> Door System, Mirror System & Window System >> Repair Instructions >> Door Replacement - Rear >> Removal Procedure

Removal Procedure

  1. Remove the body hinge pillar trim panel. Refer to Trim Panel Replacement - Left Hinge Pillar or Trim Panel Replacement - Right Hinge Pillar in Interior Trim.
  2. Remove the rubber grommet from the door and the B-pillar.
  3. Remove the cross-body wire harness connector.
  4. Apply cloth-backed tape to the door and the B-pillar in order to protect the door and the B-pillar from scratches.
    5. Fig 1: Removing Door Hinge Spring
    GM489831Courtesy of GENERAL MOTORS CORP.
  5. Use the J 39761-A  in order to remove the door hinge spring. See Special Tools .
    6. Fig 2: View Of Hinge Pins
    GM294527Courtesy of GENERAL MOTORS CORP.
  6. Remove the door hinge roller pin. Refer to Hinge Roller Pin Replacement - Door .
  7. Remove the hinge pin using a soft-faced hammer and locking pliers.
  8. Temporarily install a bolt through the lower hinge in order to hold the door in place.
  9. Remove the upper hinge pin.
  10. Remove the temporary bolt from the lower hinge.
  11. Remove the door from the vehicle.
  12. Remove and discard the door hinge pin bushings.
scientia non olet · About Mike's Workshop Manuals