Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2004 >> Sierra 2500, 4D Pickup, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the ignition control module (2) and heat sink (3).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install ignition control module (2) screws.

    Tighten:  Tighten the screws to 3.5 N.m (31 lb in).

  3. Connect the ignition coil driver electrical connector (3).
    4. Fig 1: View Of Ignition Control Module Assembly
    GM690078Courtesy of GENERAL MOTORS CORP.
  4. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About Mike's Workshop Manuals