Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2004 >> Sierra 2500, 4D Pickup, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls - 4.3L (Introduction)) >> Repair Instructions >> Accelerator Controls Pedal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the accelerator pedal.
  2. Install the end bushings to the pivot shaft.
  3. Install the end bushing retaining clips.
  4. Install the accelerator cable through the slot in the accelerator pedal lever.
  5. Seat the retainer (3) in the accelerator pedal lever (2).
    6. Fig 1: View Of Accelerator Cable Tangs, Pedal Lever & Cable Retainer
    GM372959Courtesy of GENERAL MOTORS CORP.
  6. Inspect for the following:
    • Complete throttle opening and closing with no binding
    • Proper carpet fit under the accelerator pedal
  7. Install the driver side knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages, and Console.
scientia non olet · About Mike's Workshop Manuals