Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2003 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System And Washer System >> Repair Instructions >> Wiper Motor Module Replacement >> Installation Procedure

Installation Procedure

  1. Install the circuit board and terminal module.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the cover and three screws.

    Tighten 

    Tighten the screws to 2.6 N.m (23 lb in).

  3. Install the wiper motor electrical connector.
    Fig 1: Circuit Board & Terminal Module
    G01476428Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals