Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the wiring harness clips (2) to the seat back frame.

Fig 1: View Of SIR Wiring Harness, Lumbar Wiring Harness & Retaining Clips
Courtesy of GENERAL MOTORS CORP.
Install the lumbar wiring harness (3) to the seat back frame.
Install the SIR wiring harness (1) to the seat back frame.
Install the side impact module tub to the seat back frame with 2 push pins (1).

Fig 2: Identifying Side Impact Module Tub Push Pins
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the inflatable side impact module to the seat back frame with 2 screws (1).
Tighten: Tighten the side impact module screws to 9 N.m (80 lb in).

Fig 3: Locating Inflatable Side Impact Module Retaining Screws
Courtesy of GENERAL MOTORS CORP.
Install the seat belt and retractor assembly. Refer to SEAT BELT BUCKLE REPLACEMENT--FRONT .
Install the lumbar assembly. Refer to Lumbar Replacement - Front Seat .
Install the front seat back panel. Refer to Seat Back Panel Replacement - Front .
Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
Install the front seat back. Refer to Seat Back Replacement - Front .
Install the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
Install the seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket .