Mike's Workshop Manuals: Service manuals for every vehicle
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1326 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Socket Wrench, Box End Wrench And Pulley
    GM838634Courtesy of GENERAL MOTORS CORP.
  1. Install the pulley (3) to the generator.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut using a box end wrench (2) and a socket wrench (1). Tighten the nut with the box end wrench while holding the rotor shaft with the socket wrench.

    Tighten:  Tighten the pulley nut to 111 N.m (81 lb ft).

  3. Install the generator to the vehicle. Refer to Generator Replacement .
scientia non olet · About Mike's Workshop Manuals